Thingiverse
3D printed tool hanger
door igorF2
1.1k
Downloads
907
Likes
1
Makes
Made this modular tool holder to keep my tools (screewdrivers, hex drivers, calipers, pliers, hammer, etc.) organized on my desk.
It was designed to be installed on my office, in a 25 mm gap between two wood pannels, without fasteners. I added a backside hole later, so that the modules might also be wall mounted using some screws (actually I didn't test this method).
Instructions on how it was designed at https://www.instructables.com/id/3D-Printed-Tool-Hanger/
Did you know you can buy an Anet A8 only $165.99? Get yours at Gearbest:
http://bit.ly/2kqVOdO
It was designed to be installed on my office, in a 25 mm gap between two wood pannels, without fasteners. I added a backside hole later, so that the modules might also be wall mounted using some screws (actually I didn't test this method).
Instructions on how it was designed at https://www.instructables.com/id/3D-Printed-Tool-Hanger/
Did you know you can buy an Anet A8 only $165.99? Get yours at Gearbest:
http://bit.ly/2kqVOdO
igorF2 publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
