3D Printer Cover

I recently purchased a Cocoon Create Touch. It will print ABS, unlike my Deltaprintr. But it is way too cold here at the moment so it needed a cover. My junk pile has lots of old TV and Ham radio antennae so I cut lengths of the tube to make a frame and covered it with bubble wrap.
Print 6 x FrameCorners, 2 x TopFront1 and that is the box. You could just print 8 x TopFront1 corners instead as I did. The only difference is the extra hole for the front DoorTop to hang in.
1 x DoorTop and another but reversed.
2 x DoorBTM and the front door is done.
The pins on the DoorTop parts sit in the holes of the TopFrame1 parts.
Another option that I have not done yet is a swinging door.
2 x DoorHinge for the swinging side and 2 x DoorBtm.
Then on the box, have 1 x FrameHinge2 and another swapped to have the door clip into.

A flap cut in the bubble wrap allows access to the controls, and a clear bit of plastic packaging makes a window.
NOTE!! I "measured" the tube to be 9mm but it is ac