Thingiverse
3d Printer Enclosure Cable Pass Thorugh
von usafgadget
6
Downloads
6
Likes
0
Makes
This is a simple threaded hole washer/bolt combination I designed to allow the cables from the control box to pass through into the enclosure>printer.
You will need to print the washer twice to secure the main piece (bolt) against the enclosure housing.
You will need to print the washer twice to secure the main piece (bolt) against the enclosure housing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
