Thingiverse
3D printer enclosure frame corner
von 11arctos
988
Downloads
791
Likes
0
Makes
This is a corner for a frame made for 1/2" tubes to can make a termal isolation enclosure frame for your 3D printer. The holes are slightly oversized so you can glue the tubes in. You can make 8 of these for your cube, then cut the tubes to fit your printer. The cover can be made from thin roof isolation foam (https://www.insulation4less.com/) or car sunshades cut to size and sewn.
You can complement the enclosure with a thermometer corner bracket
https://www.thingiverse.com/thing:5567681
and a fan frame that holds on to the 1/2" tube.
https://www.thingiverse.com/thing:5575821
You can complement the enclosure with a thermometer corner bracket
https://www.thingiverse.com/thing:5567681
and a fan frame that holds on to the 1/2" tube.
https://www.thingiverse.com/thing:5575821
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!