Thingiverse
3D printer PSU case
von Simon_prints
5
Downloads
3
Likes
0
Makes
I designed this PSU case to fit my standard size PSU to a 2020 aluminum frame.
It's flush with the frame at the inside.
It contains 2 screw holes (M3x10) to secure the back side of the PSU to the print, this is not required.
It's designed to be symmetrical to the RAMPS 1.4 & MOSFET case by Lokster
(which is a brilliant design, i 100% recommend it)
https://www.thingiverse.com/thing:3039756
Always be safe when working on high voltages
cheers
It's flush with the frame at the inside.
It contains 2 screw holes (M3x10) to secure the back side of the PSU to the print, this is not required.
It's designed to be symmetrical to the RAMPS 1.4 & MOSFET case by Lokster
(which is a brilliant design, i 100% recommend it)
https://www.thingiverse.com/thing:3039756
Always be safe when working on high voltages
cheers
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!