Slicer Discord
3D Printer Scanner 2in1 kit – Modèle 3D imprimable de Thingiverse Thingiverse

3D Printer Scanner 2in1 kit

par maximscy
200 Téléchargements
155 Likes
0 Makes
Voir le modèle
Can we put 3D printer and 3D scanner all into one like printer?


Hello everyone. David-3d is a kind of 3D laser scanning software and hardware with good quality and low price. But manual scanning could bring tiredness and bad results; projector is too expensive and heavy; and the PCB circuit board of the stepping motor is difficult to make. Therefore I think of driving the laser transmitter by 3D printer itself.


Most of the friends in this forum have 3D printer by official or unofficial replicator, so I use its Z axis lever. Different from the traditional scanning method, the camera and the scanned object move up and down, while the laser transmitter stays still. Actually they have the same principle.

youtube video: http://www.youtube.com/watch?v=EVCVHvah5BA

Please buy laser transmitters with the diameters of less than 15mm. there is screw hole on the holder for installing the camera. Please open replicatorG software to control the Z axis. I also design a square tray to pu
Source
Thingiverse
Ce qu'il faut pour imprimer: Intermédiaire Confiance faible
Monobloc Visserie requise
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 1/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
Polycarbonate
Post-traitement
Visserie
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection