3D Printer Tool Bench/Rack (Stud Mount)

I needed a rack to keep all of my 3D printer tools/accessories neatly organized. Since my printer is housed in an unfinished portion of my basement, I designed a rack that fits between two exposed wood studs so I could screw it between them. Thus, I designed this rack to be 264mm in width. If your studs are not that spacing, you may need to adjust the model. Sorry, I had not yet learned parametric modeling when I built this model, so you'll have to adjust it by hand. Or add wood shims. ;-)

This rack organizes the following:
* A multitool (e.g. Leatherman), needle-nose pliers, and the flush snippers (or any three similar two-handled tools)
* A power plug (I haven't installed a switch for my PSU, so when I'm not using it, I unplug my 3D printer and hang the plug from this rack, keeping it off my workbench)
* 9 slots for tweezers or binder clips
* 3 sizes of screw drivers
* An X-acto knife (blade down into a slot for safety)
* A 3D print removal tool (long spatula)
* 5 box cutte