3D Printer TPU Feet

I wanted to raise up my Fokoos Odin-5 F3 printer a bit more than the stock feet so that I could stick a microSD to standard SD adapter on the bottom of the printer, so I needed to raise the printer about another 8mm. I also made this a bit wider at 25mm instead of the stock 20mm.

I used the original M4x12 screw and washer from the factory feet, but use whatever length works for your situation. The holes were made for an M4 screw with a flat washer. There's a 3mm layer that will be between the washer and your printer.

Ideally, TPU will give the best non-slip results, but feel free to use the filament of your choice.