Thingiverse
3D-printerbed calibration
von askmurphy
12
Downloads
2
Likes
0
Makes
This nice printerbed calibration is designed with FREECAD. I have designed this for my Craftbot Plus printer but it can be used for every 3D-printer ofcourse. You can use and adapt this design for your own needs. I have added the Freecad-file also.
The original size of my design was for a 250x200 printerbed, but because I use a glass bed I have made it smaller: 190x140. Overall thickness is 2mm. The thicker calibration tabs are all 5mm.
How to use it:
Just print it and measure the heights in all corners to see if they have the same height. Also look at the flat surfaces: they must be looking good and flat too.
Adapt your bed if needed and print it again if you like.
The original size of my design was for a 250x200 printerbed, but because I use a glass bed I have made it smaller: 190x140. Overall thickness is 2mm. The thicker calibration tabs are all 5mm.
How to use it:
Just print it and measure the heights in all corners to see if they have the same height. Also look at the flat surfaces: they must be looking good and flat too.
Adapt your bed if needed and print it again if you like.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
