Slicer Discord
3D pyramid – 3D-Druckmodell von Thingiverse Thingiverse

3D pyramid

4 Downloads
8 Likes
0 Makes
Zum Modell
The Great Pyramid of Giza (also known as the Pyramid of Khufu).is the oldest and largest of the three pyramids in the Giza pyramid complex in Cairo, Egypt.
It is the oldest of the Seven Wonders of the Ancient World, and the only one to remain largely intact. pls check the wiki.
The height of the pyramid is146.7 metres (481 ft) and the base is 230.34 metres (756 ft) with the slope of 51°52'.

I design this playful 3D pyramid based on the Khufu's and scaled it down to 0.03% (1:3316)

When I was young, people always linked the pyramid to Aliens intelligence. So perhaps the UFO has something to do with it, or NOT.

Here, we have an UFO delivers the peak(first segment) of the pyramid to the shells, which the Egyptian (not Israelites) finished most of it.

wait a minute, is it Stargate 1994 movie? And Prince of Egypt 1998 is wrong !!

And finally, the UFO miraculously raised the pyramid from its ground. (magnets, of course)

PLA,0.2mm, 5% infill, 5 stl files, total of 2.5 h
Quelle
Thingiverse
Was du zum Drucken brauchst: Fortgeschritten Mittlere Konfidenz
Warum?
5-teiliger Zusammenbau · aufwändige Nachbearbeitung
5 Teile zum Zusammenbau Hardware nötig
Supports 1/3
Zusammenbau 2/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Ca. Druckzeit
2.5 h
Nachbearbeitung
Kleben, Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen