Thingiverse
3D stand for AXM Space Shuttle
door AXM61
0
Downloads
1
Likes
0
Makes
This is a stand compatible with the AXM Space Shuttle orbiter with open payload. It is based on the actual stand for the Atlantis attraction at Kennedy Space Center, with the same degree inclination of 43.21 degree.
It's a simple design of only two pieces. Now you can display your AXM Shuttles. Enjoy!
Update as of May 8, 2022: Version 2
Both supports now are beveled and a third component has been added. The bottom section is glued to both vertical supports, making it easier to put the Shuttle model on top of the stand.
Final update as of May 17, 2022: Version 3
Now you can use magnets instead of glue. All three stand components have perforations for magnets. The magnets to be used need to be 2 mm in diameter and 1 mm in depth.
It's a simple design of only two pieces. Now you can display your AXM Shuttles. Enjoy!
Update as of May 8, 2022: Version 2
Both supports now are beveled and a third component has been added. The bottom section is glued to both vertical supports, making it easier to put the Shuttle model on top of the stand.
Final update as of May 17, 2022: Version 3
Now you can use magnets instead of glue. All three stand components have perforations for magnets. The magnets to be used need to be 2 mm in diameter and 1 mm in depth.
AXM61 publiceert ook op
49 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
