3Denglasse Bong

I decided to try to make a version of the studenglasse that would be 3d printed and use a different valve design. This version has a 2 flip 'cycle' to hit. Start with 3 holes facing up, flip while lighting the bowl so the three holes face down (when 3 holes are facing DOWN this is the 'hit' flip where air is coming from the intake AND going out the outtake), then plug the outlet with your thumb and flip so the three holes face up (this is the air filter flip, air moves from one chamber to the next, no hit yet), at this point the bong has hit the bowl and filtered the smoke one last flip so the 3 holes face DOWN and the smoke comes out the outlet (you may need to do multiple cycles to clear the air in the bong as this version keeps some smoke inside and hits over multiple cycles)


Print the bong adapter and 3 pipes (2 go in the inlet holes and 1 in the outtake port so you can smoke), alternatively just print the bong adapter and get 10mm pipes from home depot.


The prototype I m