Thingiverse
3Digi flybarless system custom case
von PascalR11
1
Downloads
1
Likes
0
Makes
Custom case for the 3Digi flybarless system using the original R² PCB and screws from the green case. Finally all black everything!
This custom design has two spots on one side of the housing to easily drill holes when using the "High Current" variant. All connectors are easily accessible and should fit with minimal tolerances. The RC connectors have a tight fit for safety reasons. Futaba style and JR style connectors work flawlessly.
You might need to adjust the tolerances for the PCB with a cutting tool because every printer and every filament is different. Print settings below.
This custom design has two spots on one side of the housing to easily drill holes when using the "High Current" variant. All connectors are easily accessible and should fit with minimal tolerances. The RC connectors have a tight fit for safety reasons. Futaba style and JR style connectors work flawlessly.
You might need to adjust the tolerances for the PCB with a cutting tool because every printer and every filament is different. Print settings below.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!