3DMacAttack Filament Guide 2.0

Revised another remix to add relief cuts for the screw heads, allowing the guide to sit flush with the horizontal frame. Also added spacer to take up gap underneath arm of guide and additional vertical stabilization to keep the guide from moving or tilting while printing.

2.0 model:

Spacer is now printed separately and not built on the guide. It can be glued in place after printing.

I used 45% infill to allow rigidity with some flex and supports are optional.

** Fitment on the spool bracket is very precise and will likely require you to press down on one side and tap the other side with a small hammer or heavy object.