3DMAZE

How to play this maze.
Prepare a steel ball with a diameter of about 12mm and play through the maze.
The place between the two panels marked "IN" on the surface of the maze is the entrance (start) of this maze.
The exit "goal" is located between the panels marked "EX" and "IT" on the surface of the maze.
There is a small ledge in the maze, so you can only go through the correct path.

The answer to get through this maze is in "RouteToEXIT.txt".
When the maze is placed so that the entrance is located at the lower right, the left end of the bottom layer is the three-dimensional origin (1,1,1).
Write (X, Y, Z) to represent your current location in the maze.
The X axis increases from left to right in the order 1 -> 2 -> 3 -> 4 -> 5.
The Y axis increases from the front to the back.
The Y axis increases from bottom to top.
To indicate a start with this rule, display (5,1,1).
Similarly, the goal is displayed as (1,5,5).

Adjust the slicer print scale parameters to match the dia