Thingiverse
3DTouch Mount
par wrench_bender
3
Téléchargements
2
Likes
0
Makes
The BLTouch mount put the 3DTouch I got from Trianglelab too low, so I raised the mount up higher, and added some adjustability to the mounting holes to fine tune the position. I also move the sensor a little closer th the hotend.
I have printrd and fitted it to the backplane, but have not measured the offsets yet. I'll post them when I get it installed and checked.
I have printrd and fitted it to the backplane, but have not measured the offsets yet. I'll post them when I get it installed and checked.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !