3dverkstan Nerys Remix for making "The Stack"

Some printers work great some give me a gorgeous fused solid block of plastic :-) I have come up with a revision 4 test sample for 200x200 bowden and Delta. Give it a shot and let me know if it works for you. if it works on a bunch of machines I will make the full 35 stack. got it down to 30 minutes per as well!!!

On my Flsun Q5 it printed gloriously and I did not need any tools. twist crack pulled them apart with just my fingers!!!

Going to try on more machines now

------------

First Test print of Final Code done. SUCCESS !! I was able to get them apart. Use a small screw driver on the temple begs wedge apart then you can use your fingers to pull them apart !! Sweet !! Reset temp to 200c if that don't work just bump the temp up a tiny bit (first few layers are still higher temp for good bed adhesion)

Gcode and Factory Files updated. DD is Direct Drive without DD is Bowden HO is "heat off" at third visor (saves a ton of power) so The Stack is Bowden heat on entire print.