Slicer Discord
3inch Aeroring X – Modèle 3D imprimable de MakerWorld MakerWorld
RC

3inch Aeroring X

par Aerobot2 · RC
41 Téléchargements
12 Likes
10 Makes
Voir le modèle
The Aeroring was designed to be flown as a PLUS, however recent trends and YouTubers suggest that the X configuration is better!!So the Model has also been designed as an X. Here is one simple example. Imagine the drone is cruising along at an angle of 45 degrees, 100 kilometers per hour, then you initiate a full 360-degree right roll. Here’s what happens:In a Plus frame, only the right motor slows down, and the left motor speeds up to create the roll, while the front and rear motors maintain consistent thrust. This balance ensures the drone retains altitude throughout the maneuver. Perfect for doing (flippyfloppys) acro flying!!Now compare that to an X frame. During the same 360-degree roll, two motors on one side slow down, and two on the other side speed up. Which leads to altitude loss. To combat this they are relying on more authority of the two motors that speed up and some snappy rates with higher PID's for the Roll Axis. This is not natural and is band aiding your flying st
Catégorie
RC
Source
MakerWorld
Publié
Mis à jour
Ce qu'il faut pour imprimer: Débutant Confiance faible
Monobloc
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 0/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection