Tools
Ver Modelo
3mm tube bender
192
Descargas
142
Likes
0
Makes
Here's a very small tube bender, designed for use on __3mm__ hollow brass tube.
I needed this to fabricate a new choke tube for a Mikuni BT carburettor.
Additional parts required:
----------------------------------
2 x M5 x 25 bolts
2 x M5 nuts
4 x washers
Instructions for use
---------------------------
1. Position the bender base and handle to roughly 90° and insert the tube between the two grooved forms.
2. Gently clamp the bender base and the tube in a vise, or just wrap some tape around the tube and base to hold them together
3. Rotate bender handle until the desired bend angle is formed.
See photos for reference.
I needed this to fabricate a new choke tube for a Mikuni BT carburettor.
Additional parts required:
----------------------------------
2 x M5 x 25 bolts
2 x M5 nuts
4 x washers
Instructions for use
---------------------------
1. Position the bender base and handle to roughly 90° and insert the tube between the two grooved forms.
2. Gently clamp the bender base and the tube in a vise, or just wrap some tape around the tube and base to hold them together
3. Rotate bender handle until the desired bend angle is formed.
See photos for reference.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!