3rd Reality Switch additional Retainer

If you have a 3rd reality switch (They are used for actuating traditional switches) you'll find that sometimes people will try to lift the switch from the bottom. This additional side grippers allows you to keep the unit in place a bit better. You can use this with the origial buttons, just place it behind the button and screw it down tight. To insert it into the grips, insert the right side on an angle and gently move the clips to allow it to move into place. Then align with the buttons and attach to the buttons. It takes a bit of trial and error but once you get it you'll find its easy to insert. One final note. You'll notice an offset in the hole. That is intentional, it will align properly with both sides of the unit, the battery compartment causes it to be off-center. Just be sure the short side is opposite the battery compartment. They easily rotate on the wall if you make a mistake. Thanks to makersplayz for the suggestion to build these!