3X Ceiling LAN cable mount.

This is a 3X LAN cable holder. They are thin enough to be printed in batches and, strong enough to handle an acute angle between the ceiling and the wall. The holes have been tested on just one LAN cable. They are mounted with 3M poster command strips to the corner of the wall and ceiling.

1. Apply 2 poster 3M command strips to the "legs" of the print
2. Apply pressure to the recently applied strips against the print for one minuet.
3. Have a small angle between the leg and the wall it is touching.
4. Rock the LAN Mount into the wall (while holding the leg on the wall), closing the angle and, forcing the other leg into the ceiling.
5. Press firmly on the LAN Mount at the points where the stickers are on the other side.
...
6. Press LAN/WAN cable into the one of three slots.

I mean, It looks good to me. Those legs are long cause' I noticed that the wall and ceiling doesn't make a 90 DEG angle. Those legs bend, allowing the entire sticker to be used on the surface. The forces