3x3 Rubik's cube/Magic cube

The cube turns very well, with my main cube I average 12 seconds and with this cube I can average less than 20 seconds. I recomend you to sand every piece. You will need 6 M3x12 screws and 6 springs. If you make it stickerless, you will be able to put magnets (Diameter 3mm and height 1mm), you will need 48 magnets. If you make the cube stickerless, you will need to glue the pieces. For the core I used a Qiyi core, but it can be printed.

Parts to print:

Stickered:

-x12 Complete edge.
-x8 Complete corner.
-x6 Center.
-x6 Center cap.
-x1 Core (You can also use a Qiyi core).

Stickerless/magnetic:

-x24 Part of edge.
-x24 Part of corner.
-x6 Center.
-x6 Center cap.
-x1 Core (You can also use a Qiyi core).