4-1_PTFE_Adapter

Basically got tired of waiting for this to come back in to stock. Its a little longer than it probably need to be but works well. I say longer because for the P1S with enclosure the tube sticks out the back and the distance between the tube and screw locations is a little shorter than I made this. But if you look at the Bambu pics, on the P1S its not screwed on. The P1P(no enclosure) PTFE tube comes out the top, hence the rotation slot for mounting. This should work just fine for that.

I left the mount block big enough to use double-stick tape for the enclosed printers.

The other reason I made this is the other designs out there have the through holes too small. There is no need for tight tolerances there so mine are at 4mm. And only tapers where the filament goes in to the single end (see section analysis pic)

I used pc4-m10 fittings from Amazon but could have used m8 or m6 instead.