Thingiverse
4" Dust Hose Mount
by Maxxra
12
Downloads
2
Likes
0
Makes
To be used with 4" worm gear clamp (assumed to be .5" wide).
Directions: Unscrew clamp via worm gear until apart. Pass through the center of the mount and re-attach the clamp. Screw mount into wall (I use 2" woodscrews with washers) and tighten the worm gear.
Printed on Lulzbot Taz5 & Mini without struts or supports (overhang seems to hold nicely) with PLA. Layer height apx .20
Works well with t-joints and dust gates too.
Directions: Unscrew clamp via worm gear until apart. Pass through the center of the mount and re-attach the clamp. Screw mount into wall (I use 2" woodscrews with washers) and tighten the worm gear.
Printed on Lulzbot Taz5 & Mini without struts or supports (overhang seems to hold nicely) with PLA. Layer height apx .20
Works well with t-joints and dust gates too.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
