Thingiverse
4 " inch dust separator cyclone
von 3D_Blue_Prints
1.3k
Downloads
813
Likes
4
Makes
For experienced makers.
Remember this is a free file.
Ready to get your socks sucked off?
This is a handy dandy, print-it-yourself cyclone!
If you are looking to upgrade your dust collection system, we highly recommend giving this design a test run. It has been designed for maximum airflow through a 4" duct system.
This has been tested under harsh conditions (powder coating area) and performs very well.
===================
Dimensions:
===================
Inlet - 4"
Outlet - 4"
Dropoff - 6"
Total Height - 20"
Largest diameter - 8"
===================
Printing Notes:
===================
*Support on the top piece only.
*Make sure to orient parts properly (optimized for your printer) in the preferred slicer software.
*10 perimeters
*Filament of choice (PLA, PETG, etc)
===================
Assembly Instructions:
===================
Note: Please make sure to have your superglue ready - it will be used for multiple steps!
1. Af
Remember this is a free file.
Ready to get your socks sucked off?
This is a handy dandy, print-it-yourself cyclone!
If you are looking to upgrade your dust collection system, we highly recommend giving this design a test run. It has been designed for maximum airflow through a 4" duct system.
This has been tested under harsh conditions (powder coating area) and performs very well.
===================
Dimensions:
===================
Inlet - 4"
Outlet - 4"
Dropoff - 6"
Total Height - 20"
Largest diameter - 8"
===================
Printing Notes:
===================
*Support on the top piece only.
*Make sure to orient parts properly (optimized for your printer) in the preferred slicer software.
*10 perimeters
*Filament of choice (PLA, PETG, etc)
===================
Assembly Instructions:
===================
Note: Please make sure to have your superglue ready - it will be used for multiple steps!
1. Af
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!