4 Max Pro Temperature Gauge

Hi All! I wanted to install a Temperature Gauge to control the inside Temp of my 4 Max Pro …to give me all Chances of a Good ABS Print I prefer Heating up the inside of the Printer to around 35 Deg Celsius before staring the print itself … it does not take too long to get to that point ,anyhow here is my Rendition of a Temp Gauge Installation ,including 2 kinds of Gauge holders(depending if you want to install on the side or on the top of the Printer) and a Cable/sensor bracket/holder that will give you the opportunity to install it without any glue and as such is easier to remove if wanted… of course there will be a 10 mm Hole that will need to be Plug and that is easy for us Makers…the Principle is simple I have slotted both parts to be able to insert de Probe and wire in the Male Part A and then you only have to push the female part B into part A ,,, just be sure not to align both Slots for a Better Seal (even if the 4Max Pro is not completely seal) I am using this temp gauge f