Thingiverse
4 Max Pro Tools Holder
von DaakTwo
9
Downloads
5
Likes
0
Makes
Hi all.. !
This is the First Design I just did for the “Anycubic 4 Max Pro”... it is a Tool Holder for most of the small tools that comes with the Printers including the SD Card and the SD card reader… Easy to install with Double side tape or Velcro like I did because I like to Change the side it is installed on if needed …so the print is done at .320 layer with 15 % infill, No Raft or Support needed, Done in Pla with the Nozzle at 200 deg and the Bed at 60 because I am using a Ultrabase on my i3 Mega.. Remember always have fun when printing
This is the First Design I just did for the “Anycubic 4 Max Pro”... it is a Tool Holder for most of the small tools that comes with the Printers including the SD Card and the SD card reader… Easy to install with Double side tape or Velcro like I did because I like to Change the side it is installed on if needed …so the print is done at .320 layer with 15 % infill, No Raft or Support needed, Done in Pla with the Nozzle at 200 deg and the Bed at 60 because I am using a Ultrabase on my i3 Mega.. Remember always have fun when printing
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
