Thingiverse
4 Part Face Shield
von ESKIM0
10
Downloads
3
Likes
0
Makes
This face shield frame is broken down into 4 pieces that can all fit onto the 4.9" x 4.9" bed of a Snapmaker (of course it will fit any other small printer too).
Printed with a .4mm nozzle, .3mm layer heights, no infill, and minimal supports, one frame can be printed per hour.
This model works with letter sized transparencies and a US 3-hole punch. But I used A4 laminated sheets and approximated the holes with a single hole punch. The plastic will stretch over the studs and hold tight.
Printed with a .4mm nozzle, .3mm layer heights, no infill, and minimal supports, one frame can be printed per hour.
This model works with letter sized transparencies and a US 3-hole punch. But I used A4 laminated sheets and approximated the holes with a single hole punch. The plastic will stretch over the studs and hold tight.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
