Thingiverse
4 part rotor (FDM printable)
door Muthinor
0
Downloads
2
Likes
0
Makes
This is a little remix i did in order to print the Rotor with Minimal Supports.
I had to remodel each piece so its a "close replica", with just a few changes on parts where it was necessary. at simple eye you wont notice them.
1 img: the parts altogether.
2 img: Original model in the same place of my remix just so you can check that it's faithful
3 img: How the parts intersect eachother.
(thingiverse put the order however it desires...)
Someday i'll upload the piece Printed, it's being printed right now.
Big shoutout to chriswh86 For creating the original model
I had to remodel each piece so its a "close replica", with just a few changes on parts where it was necessary. at simple eye you wont notice them.
1 img: the parts altogether.
2 img: Original model in the same place of my remix just so you can check that it's faithful
3 img: How the parts intersect eachother.
(thingiverse put the order however it desires...)
Someday i'll upload the piece Printed, it's being printed right now.
Big shoutout to chriswh86 For creating the original model
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!