MakerWorld
Vehicles
Zum Modell
4 Pin Trailer Plug Holder
241
Downloads
77
Likes
173
Makes
Tired of letting your trailer plug just hang in the elements when not in use? Tired of it dragging on the ground when its not plugged in? This is an extended remix of the original model from a few years back. This should hold most 4-pin plugs pretty snug. There is a drainage hole for if condensation builds up or if somehow rain makes it in so the plug is not sitting in standing water. Printed in TPU to ensure a snug fit. Have not attempted in PLA/PETG/etc. Secures to the trailer with self-tapping screws. No supports needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
