Thingiverse
40-mm E3D Fan
door poken1151
182
Downloads
121
Likes
3
Makes
***NOTE*** This is a remix of a fan part I got off thingiverse months ago, I can't seem to find it at this time (there's another remix that has a similar note as this). It was, according to the file I have saved, called 40-mm E3D Fan....
This fan has a valve built in to allow a small 1/8th turn to control fan flow. My MP Select Min refuses to listen to the fan, so I made this so that I could keep the vent closed on the first layer of some prints, then open in it up afterwards.
The print's still a WIP. Here are some notes and issues:
- I'm sure it's not the model, but my ABS version of this is fragile at the neck between the e3d clasps and the main body.
- Id print with supports EVERYWHERE, granted this will need some cleaning up with a stencil knife or similar.
- You'll wanna apply a tiny bit of forces as you clean up too get the valve to turn, but it should all go well, printed it twice.
This fan has a valve built in to allow a small 1/8th turn to control fan flow. My MP Select Min refuses to listen to the fan, so I made this so that I could keep the vent closed on the first layer of some prints, then open in it up afterwards.
The print's still a WIP. Here are some notes and issues:
- I'm sure it's not the model, but my ABS version of this is fragile at the neck between the e3d clasps and the main body.
- Id print with supports EVERYWHERE, granted this will need some cleaning up with a stencil knife or similar.
- You'll wanna apply a tiny bit of forces as you clean up too get the valve to turn, but it should all go well, printed it twice.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
