Thingiverse
40 mm fan guard/guide
por bbo
12
Descargas
9
Likes
0
Makes
This is a remix of NeverDun's fan guard, he made a design that actually optimizes air flow and protects the fan blades. I made a version with a couple of air flow tricks.
…
It is now printable without support
2 shells
3-10% infill
video of it running is here;
https://www.youtube.com/watch?v=ssyXqWaOjxo
…
Original article here:
http://open3dp.me.washington.edu/2014/11/flashforge-creator-x-reducing-mass-improving-build-quality/
The SCAD version in only 40mm friendly, I will parameterize the SCAD and publish it if there is enough interest in that level of control.
…
It is now printable without support
2 shells
3-10% infill
video of it running is here;
https://www.youtube.com/watch?v=ssyXqWaOjxo
…
Original article here:
http://open3dp.me.washington.edu/2014/11/flashforge-creator-x-reducing-mass-improving-build-quality/
The SCAD version in only 40mm friendly, I will parameterize the SCAD and publish it if there is enough interest in that level of control.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
