Thingiverse
USB extension cable end holder and rail clip for 20x20 rails
by ronschauer
11
Downloads
10
Likes
0
Makes
These fit typical 20x20 t-slot-rails such as are used on 3D printers and other applications.
The cable clips are used to contain cables and wires inside the t-slots.
I have also re-mixed this in a version for more generic usage at- https://www.thingiverse.com/thing:4050715
The clamp set fits standard USB cable ends having a 17mmx9.5mm profile snugly.
Note that the interior height of the cover is actually only 8.5mm so it will not clamp completely against the tab (small gap).
This was
The cable clips are used to contain cables and wires inside the t-slots.
I have also re-mixed this in a version for more generic usage at- https://www.thingiverse.com/thing:4050715
The clamp set fits standard USB cable ends having a 17mmx9.5mm profile snugly.
Note that the interior height of the cover is actually only 8.5mm so it will not clamp completely against the tab (small gap).
This was
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in