Thingiverse
403Mhz Dipole
door kirovoleg
4
Downloads
2
Likes
0
Makes
Dipole antenna for 403Mhz.
I wanted to receive the weather balloons sent every morning by a nearby airpoirt, so I designed this dipole support.
I printed it in PETG in order to withstand the weather. Though I have some PLA+ prints outside that are working well so far..
The dipole consist of 2 pieces of about 17cm long and 2.6mm diameter Bronze soldering bars.
The dipole is soldered directly to RG58 coax and then it is covered in hot glue.
There is also a cover that fits snugly on top of the dipole which I also glued with the hot glue gun.
The larger hole is for an 8mm diameter wooden dowel that acts as a mast which I also glued, though it fits quite snug.
I wanted to receive the weather balloons sent every morning by a nearby airpoirt, so I designed this dipole support.
I printed it in PETG in order to withstand the weather. Though I have some PLA+ prints outside that are working well so far..
The dipole consist of 2 pieces of about 17cm long and 2.6mm diameter Bronze soldering bars.
The dipole is soldered directly to RG58 coax and then it is covered in hot glue.
There is also a cover that fits snugly on top of the dipole which I also glued with the hot glue gun.
The larger hole is for an 8mm diameter wooden dowel that acts as a mast which I also glued, though it fits quite snug.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!