Thingiverse
4040 Filament Spool Roller
von CCJ
0
Downloads
0
Likes
0
Makes
I modified the original design to use a M5 screw.
For the knob I used a M5 20mm bolt I purchased from Home Depot and M5 4040 t-nuts I purchased on Amazon.
The guide fits really tight due to tight tolerances so may need trimming and force to snap into place.
For the knob I used a M5 20mm bolt I purchased from Home Depot and M5 4040 t-nuts I purchased on Amazon.
The guide fits really tight due to tight tolerances so may need trimming and force to snap into place.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
