Slicer Discord
4040 motor bracket – 3D-printbaar model van Thingiverse Thingiverse

4040 motor bracket

1 Downloads
2 Likes
0 Makes
Model downloaden
This bracket enables a nema 17 59mm to be fitted onto 4040 extrusion for dual z vertical motion. The reason for this is to move the vertical rails from the sides and house them between the rails so that you will gain a little extra width for the heat bed left and right but lose a little height. The groove on one side allows the wiring to be directed into the 4040 extrusion for a neater install. If you print this is PLA you will need a low amp motor as the heat will melt it, PETG would be better. the design is off centered because the motor is 42x42 the rail 40x40 this allows a flush outside fit if you wish to box in your printer
Bron
Thingiverse
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA, PETG
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie