Thingiverse
Mendelmax Z Top with bearing mount for 10mm Lead screw and 8mm rod
by Bcrowe
8
Downloads
8
Likes
0
Makes
Mendelmax Z top.
Designed to accept a 6000 series bearing (10x26x8) to support the top end of a 10mm lead screw.
Note - Not yet printed or tested.
Also Note - Use Z-constraints like this cautiously, any distortion in the threaded rod that would normally be seen as a circular motion at the free end of the rod will be transferred to the X Ends instead and cause layer mis-allignment.
Remix of: http://www.thingiverse.com/thing:22820
Designed to accept a 6000 series bearing (10x26x8) to support the top end of a 10mm lead screw.
Note - Not yet printed or tested.
Also Note - Use Z-constraints like this cautiously, any distortion in the threaded rod that would normally be seen as a circular motion at the free end of the rod will be transferred to the X Ends instead and cause layer mis-allignment.
Remix of: http://www.thingiverse.com/thing:22820
Sign in to leave a comment
Sign in