Thingiverse
Fan Mount for Raspberry Pi 4 with Heat Sink Case
by SF3DPrint
2
Downloads
4
Likes
0
Makes
A snap-on fan case for use with a passive heat sink case (https://www.adafruit.com/product/4341).
The fan version of that case uses those little fans that don't really push any air. This clip-on holds a Noctua 40x40x10mm 5V fan (or equivalent) to keep things cool. There's a duct to route the wires to the Pi GPIO pins to connect up. I’m only using +5 and Gnd but anyone wanting to do PWM control or RPM monitoring should keep the GPIO voltage limits in mind.
It clamps pretty tight and only ma
The fan version of that case uses those little fans that don't really push any air. This clip-on holds a Noctua 40x40x10mm 5V fan (or equivalent) to keep things cool. There's a duct to route the wires to the Pi GPIO pins to connect up. I’m only using +5 and Gnd but anyone wanting to do PWM control or RPM monitoring should keep the GPIO voltage limits in mind.
It clamps pretty tight and only ma
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in