Thingiverse
Solar Tracker
by langes
52
Downloads
47
Likes
1
Makes
The solar tracker:
The solar tracker aligns itself to the sun with the help of four photo resistors and is always perpendicular to it. If less brightness is detected in a section, a command is sent to the Arduino Nano which then controls the servo motors to be perpendicular to the sun again.
The solar tracker is made of 3D printed PLA materials and has 2 SG90 servomotors for alignment. On a prototype board is a soldered Arduino Nano which is the brain of the solar tracker.
Additionally
The solar tracker aligns itself to the sun with the help of four photo resistors and is always perpendicular to it. If less brightness is detected in a section, a command is sent to the Arduino Nano which then controls the servo motors to be perpendicular to the sun again.
The solar tracker is made of 3D printed PLA materials and has 2 SG90 servomotors for alignment. On a prototype board is a soldered Arduino Nano which is the brain of the solar tracker.
Additionally
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in