Thingiverse
SKR V1.3 Enclosure for 2020Extrusion
by jens_corexy
13
Downloads
12
Likes
0
Makes
I designed this enclosure for the Bigtreetech SKR V1.3.
It fits to the corner of about any 2020-extrusion framed printer (Tronxy X5s in my case) and is build in 3 pieces (bottom spacer, enclosure, cover).
Depending on the orientation of the cover the 60x60 fan is centered over the board or over the X/Y drivers.
The green connector is a 16 Pin Phoenix connector (1788677).
This is the Shop with the best Picture I could find but probably not the cheapest:
https://www.digikey.de/product-de
It fits to the corner of about any 2020-extrusion framed printer (Tronxy X5s in my case) and is build in 3 pieces (bottom spacer, enclosure, cover).
Depending on the orientation of the cover the 60x60 fan is centered over the board or over the X/Y drivers.
The green connector is a 16 Pin Phoenix connector (1788677).
This is the Shop with the best Picture I could find but probably not the cheapest:
https://www.digikey.de/product-de
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in