Fractal Christmas tree
by PalRas
0
Downloads
0
Likes
0
Makes
Fractal Christmas tree
Having made this fractal figure, I thought that it - with a little good will and Christmas mood - might well resemble a Christmas tree !?
No support used, but in Cura 4.4.0 I found an Experimental feature called "Make Overhang Printable". I have enabled the function and applied the value 41 ° for "Maximum Model Angle".
I also used the "Enable Ironing" feature.
Merry Christmas (This was written on December 25, 2019)
Having made this fractal figure, I thought that it - with a little good will and Christmas mood - might well resemble a Christmas tree !?
No support used, but in Cura 4.4.0 I found an Experimental feature called "Make Overhang Printable". I have enabled the function and applied the value 41 ° for "Maximum Model Angle".
I also used the "Enable Ironing" feature.
Merry Christmas (This was written on December 25, 2019)
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in