Ender3 Board Cover
by 419mining
20
Downloads
11
Likes
0
Makes
updated Creality Ender 3 main board cover. This one is setup for the stock 40mm fan to be mounted in from below. using M3 12mm screws. The cover is 3mm thick to match the SDcard front cover. https://www.thingiverse.com/thing:3455823
after upgrading the main board to v1.1.5 and adding a buck converter for 12v fans, the case cover was way to tight, this brings the roof up 10 mm, and vents the heat out the back.
**Print upside down (fan facing the build plate)** with supports from the buildpl
after upgrading the main board to v1.1.5 and adding a buck converter for 12v fans, the case cover was way to tight, this brings the roof up 10 mm, and vents the heat out the back.
**Print upside down (fan facing the build plate)** with supports from the buildpl
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in