ENDER 3 / CR-10 Direct Extrusion Mount Bulldog

Adjesuted the mount point of the motor to allow alignment with the PTFE tubing using a Bulldog Extruder, whilst maining a dual 5015 Fan set up using the Hero Me v3 Fan shround.

I upgrade to a bulldog extruder and using the orginal Direct Drive mount, it was pushing the PTFE tubing to the right, this design moves the motor over to the left by 5mm, aligning the holes of the extrutor and heatsink. Removing any fiction being caused pushing the filament in the the hot end an a angle.

I'm curren