65mm Quad work/launch stand
by ChaoticBrain
2
Downloads
0
Likes
0
Makes
I wanted a little drone stand that was high enough to enable me to plug the USB cable in while also holding it level for accelerometer calibration.
It is too slippery to use as a launch stand, but if you added something with friction it would work.
Honestly it's over built for its use. But it's modeled after the launch stands we use for races.
It is too slippery to use as a launch stand, but if you added something with friction it would work.
Honestly it's over built for its use. But it's modeled after the launch stands we use for races.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in