Thingiverse
CR-10S Pro E3D V6 mount
by Renix_3dp
27
Downloads
18
Likes
0
Makes
CR-10S Pro E3D V6 mount.
You can use the petsfang with single fan or dual fan from https://www.thingiverse.com/thing:2759439 .
I have change the mount points for the petsfang, because I use the normal E3D V6 Hotend.
Note: Use Aluminium Tape at the bottom and inside at the hot areas of the hotend.When you print it with ABS or ASA it is not needed. When the Hotend not tight at the mounting point use aluminium foil at one side.
remix of "Petsfang V2 adapter body for E3D Volcano on CR-10s
You can use the petsfang with single fan or dual fan from https://www.thingiverse.com/thing:2759439 .
I have change the mount points for the petsfang, because I use the normal E3D V6 Hotend.
Note: Use Aluminium Tape at the bottom and inside at the hot areas of the hotend.When you print it with ABS or ASA it is not needed. When the Hotend not tight at the mounting point use aluminium foil at one side.
remix of "Petsfang V2 adapter body for E3D Volcano on CR-10s
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in