40x20mm rectangular furniture / table / bed riser

Material used: SUNLU PETGprinted for strength therefore uses a lot of filament, but it has not been stress tested. the metal bed frame + mattress I am supporting is ~100lb + me sleeping on top which is ~ another 100lb but it is supported by 9 of theseit should not be a tight fit. I made the hole 41mm x 21mm so it has some wiggle room just in case the fit is too tight there are 2 plates because 9 do not fit on 1 plate. If you want to check the fit, print 1 leg first, then print the remaining legs. If you want to just do 1 print, just clone as many as you need and auto arrange them and hope they fit on 1 plate. because 9 legs do not fit on 1 plate, i made another model that is a tad bit smaller so it prints on 2 plates, 1 with 1 leg being the tester and the 2nd plate with 8 legs on it. if anyone can make a parametric model that would be cool I have another furniture riser for circular legs