Thingiverse
Hotend 30mm fan shroud
by lucascorato
40
Downloads
31
Likes
0
Makes
Update August 8th, 2014:
---
The Parsiotto version wasn't working very well since the neck wasn't getting any air, so I updated it to a V2, with a better air flow. It's a little bulkier but it might do the trick.
Update July 31st, 2014:
---
Following MrArrow1961's requests and suggestions, I have updated the files. Now I guess they can be printed without the bridge in the middle and thermal efficiency may have been improved.
- - -
This shroud will keep air from blowing on the prin
---
The Parsiotto version wasn't working very well since the neck wasn't getting any air, so I updated it to a V2, with a better air flow. It's a little bulkier but it might do the trick.
Update July 31st, 2014:
---
Following MrArrow1961's requests and suggestions, I have updated the files. Now I guess they can be printed without the bridge in the middle and thermal efficiency may have been improved.
- - -
This shroud will keep air from blowing on the prin
Sign in to leave a comment
Sign in