Thingiverse
Hobby
Voir le modèle
Bulk Film Spooler
221
Téléchargements
240
Likes
2
Makes
A bulk loader for the film photographer!
Just add two 48x48 mm squares of felt to make the light trap. I used a thick (~2mm) type of felt. Double up if your felt is thin. Use super glue!
Print on the largest, flattest surface of each model. Use a raft at will if you're concerned the model will permanently adhere to the bed. The Crank is a nested assembly that nicely prints on its side with supports.
The version pictured was printed before I added the following "finishing touches":
Each cap is labeled with "ISO100" or "ISO400" so you can remember what's loaded.
Embossed on the side of the body is a table showing the number of turns that correspond to the number of exposures (copied from a Lloyd Loader)
Just add two 48x48 mm squares of felt to make the light trap. I used a thick (~2mm) type of felt. Double up if your felt is thin. Use super glue!
Print on the largest, flattest surface of each model. Use a raft at will if you're concerned the model will permanently adhere to the bed. The Crank is a nested assembly that nicely prints on its side with supports.
The version pictured was printed before I added the following "finishing touches":
Each cap is labeled with "ISO100" or "ISO400" so you can remember what's loaded.
Embossed on the side of the body is a table showing the number of turns that correspond to the number of exposures (copied from a Lloyd Loader)
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
