463mm MLOK Hex Handguard
33
Downloads
20
Likes
0
Makes
Barrel nut threads directly to upper receiver. Handguard threads into barrel nut and is held together with two or three M3x0.5x12 screws. You can slice the model to a shorter size if you want. Just sand and superglue the edges to put them together.
Depending on your print settings this will take about 22 hours at 0.2mm layer height and 200g (PLA filament).
Depending on your print settings this will take about 22 hours at 0.2mm layer height and 200g (PLA filament).
Leucoemeraldine also publishes on
7 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
