46mm Micro quad

Note: The original had the wrong motor hole pattern for modern 0603/0702/0802 motors, and the center hole was nowhere near enough for the c-clip usually found on these motors.

This build is quite tight on space and probably not recommended for beginners. Or anyone who is uncomfortable soldering very precisely.

Frame is printed in PLA with 0.12mm resolution, 100% infill

Camera holder, Receiver cover is printed in 95A TPU with Prusa Slicer's 0.16mm Dynamic quality, use supports for the receiver cover.

M2x12 screws, 2 need to be countersunk to make room for the Flight controller.

Flight controller: Teeny F3, though if you have the Teeny F4 that should work too. The USB plug and ESC plug slot in neatly in the gaps in the frame. I got mine here: https://www.xt-xinte.com/Teeny1S-F3-16-16mm-Betaflight-STM32F3-OSD-BEC-Flight-Control-Board-for-RC-Drone-Quadcopter-p147310.html?parent_user_id=1420080&utm_source=sns_share&utm_medium=share_line

ESC: Tiny Pepper 4in1, though you wo